Filter
Top Products
Using the System Setup Program | 75
Table 2-2. The IPMI Command Table
IPMI Command Setup Option Description
ipmitool raw 0x34 0xB1
<Byte1:4>
Byte 1 - Power
Management Enable(01h
enable)
Byte 2 - Power Capping
Enable(01h enable)
Byte 3 - Current Chassis
Power Capping Value(Low
Byte)
Byte 4 - Current Chassis
Power Capping
Value(High Byte)
SET POWER
MANAGEMENT
BEHAVIOR
The setting controls PSU Power, its
range limited in 450˜2000 W. T h e
value is sent
to BMC by IPMI
command and BMC will control
PSU power. This setting can be seen
when “Power Management” is
selected to “APML” mode and the
system board at location 2 in the
chassis.
ipmitool raw 0xc 1 1 3 <IP
Address>
IP Address Use this option to input BMC LAN
port IP address.
ipmitool raw 0xc 1 1 6
<Subnet Mask>
Subnet Mask Use this option to input BMC LAN
port subnet mask address.
ipmitool raw 0xc 1 1 12
<IP Address>
GateWay Address
Use this option to input BMC LAN
port Gateway address.
pmitool raw 0x30 1
Return: ID
ipmitool raw 0x30 3 ID
0x11 0x2 0 0 0 1 <Delay
Mode>
Power Staggering
AC Recovery
Configures power recovery behavior.
This item can be seen when
“Remote on AC Power Loss” is
selected in “Power On” or “Last
State”.
This parameter is only effective if
the Power Policy is not set to always
off.
0x00
: Immediate Power On (No
Delay) : Default
0x01
: Auto (Random), the auto
generated delay time must be in the
range of Minimum Power On Delay
and Maximum Power On Delay.
0x02
: User Defined, the user
defined delay time must be in the
range of Minimum Power On Delay
and Maximum Power On Delay.
ipmitool raw 0x30 1 Minimum Power Configures time for power on delay,