Filter
Top Products
130 | Installing System Components
4 Place the upper middle plane holder into the chassis. See Figure 3-29.
5 Replace the screws that secure the middle plane holder to the chassis.
See Figure 3-29.
6 Place the middle plane holder support into the chassis. See Figure 3-28.
7 Replace the screws that secure the middle plane holder support to the
chassis. See Figure 3-28.
8 Place the upper middle plane on the middle plane holder. Make sure
that the two stand-offs on the middle plane holder are inserted through
the slot on the upper middle plane. See Figure 3-27.
9 Replace the screws that secure the upper middle plane to the middle
plane holder. See Figure 3-27.
10 Connect all the cables to the upper middle plane.
You must route these cables properly through the tabs on the chassis to
prevent them from being pinched or crimped.
11 Place the cooling-fan bracket into the chassis. See Figure 3-26.
12 Replace the screws that secure the cooling-fan bracket to the chassis.
See Figure 3-26.
13 Replace the cooling fans. See "Installing a Cooling Fan" on page 120.
14 Replace the system-board assemblies. See "Installing a System-Board
Assembly" on page 88.
15 Close the system, see "Closing the System" on page 118.
16 Reconnect the system to its electrical outlet and turn on the system,
including any attached peripherals.