Filter
Top Products
6. Align the memory-module's edge connector with the alignment key of the memory-module socket,
and insert the memory module in the socket.
NOTE: The memory-module socket has an alignment key that allows you to install the memory
module in the socket in only one orientation.
CAUTION: To prevent damage to the memory-module socket during installation, apply
pressure at both ends of the memory module evenly. Do not apply pressure to the center of
the memory module.
7. Press down on the memory module with your thumbs until the memory module snaps into place.
Figure 15. Installing Memory Module
1. memory module 2. memory-module ejectors
3. memory-module socket alignment key 4. memory-module alignment key
NOTE: When the memory module is properly seated in the socket, the levers on the memory-
module socket align with the levers on the other identical sockets that have memory modules
installed.
8. Repeat tasks 4–7 of this procedure to install the remaining memory modules.
9. Replace the cooling shroud.
10. Install the system cover..
11. Reconnect the system to its electrical outlet and turn on the system, including any attached
peripherals.
12. Press <F2> to open the System Setup page, and check the memory settings.
The system should have already changed the value to reflect the newly installed memory.
13. If the value is incorrect, one or more of the memory modules may not be installed properly. Repeat
steps 4 through 7 of this procedure, checking to make sure that the memory modules are firmly
seated in their sockets.
14. Run the appropriate diagnostic test. For more information, see Using System Diagnostics in this
document.
Hard disk drives
All HDDs or SSDs connect to the system board through the HDD or SSD backplane. HDDs or SSDs are
supplied in hot-swappable HDD or SSD carriers that fit in the HDD or SSD slots.
45