Filter
Top Products
Troubleshooting 89
You are prompted to configure
one network instead of two
during MSCS installation.
The TCP/IP configuration is
incorrect.
The node-to-node network and public
network must be assigned static IP
addresses on different subnets. See
"Assigning Static IP Addresses to Your
Cluster Resources and Components" for
information about assigning the
network IPs.
The private (point-to-point)
network is disconnected.
Ensure that both systems are powered on
so that both network adapters in the
private network are available.
Client systems are dropping off
of the network while the cluster
is failing over.
With MSCS, the service
provided by the recovery
group becomes temporarily
unavailable to clients during
failover. Clients may lose
their connection if their
attempts to reconnect to the
cluster are too infrequent or
if they end too abruptly.
The time that the service is temporarily
unavailable varies depending on the
application. Contact the application
program vendor for more information.
Only one network segment
appears during Cluster Service
installation.
Public and private networks
segments are not unique.
Place all installed network adapters in a
cluster node on separate IP networks.
Ensure that the same network segments
that were used for each network adapter
are identical on the second cluster node.
Table A-1. General Cluster Troubleshooting (continued)
Problem Probable Cause Corrective Action
se500wbk1.book Page 89 Thursday, June 16, 2005 4:19 PM