Filter
Top Products
108 Configuring and Managing RAID
3
Press <F2> to display a menu of available actions.
The
Rebuild
option is highlighted at the top of the menu.
4
Press the right arrow key to display the rebuild options and select
Start
.
5
After you start the rebuild, press <Esc> to display the previous menu.
NOTE: You can also use the VD Mgmt screen to perform a manual rebuild. Use the
arrow key to highlight physical disk in the tree view, and press <F2>. In the menu
that displays, select the Rebuild option.
NOTICE: If a physical disk is a member of a disk group that contains multiple virtual
disks and one of the virtual disks is deleted when a rebuild operation is in progress,
the rebuild operation stops. If this occurs, you can resume the rebuild operation
manually using a storage management application. To avoid interruption, ensure
that none of the virtual disks are deleted until the rebuild is complete.
Controller Management
Enabling Boot Support
NOTE: Refer to your system documentation to ensure the proper boot order is
selected in the system BIOS.
In a multiple controller environment, you can enable BIOS on multiple
controllers. However, if you want to boot from a specific controller, then enable
the BIOS on that controller and disable it on the other controllers. The system
can then boot from the BIOS-enabled controller. Perform the following steps to
enable the controller BIOS.
1
Press <Ctrl><N> to access the
Ctrl Mgmt
menu screen.
2
Press <Tab> to move the cursor to
Enable Controller BIOS
in the
Settings
box.
3
Press the spacebar to select
Enable Controller BIOS
.
An
X
displays beside
Enable Controller BIOS
.
4
Press <Tab> to move the cursor to the
Apply
button, and then press
<Enter> to apply the selection.
The controller BIOS is enabled. To disable the controller BIOS, use the
spacebar to deselect the
Enable Controller BIOS
control, and then select
Apply
and press <Enter>.
Dell_PERC6.1_UG.book Page 108 Wednesday, April 15, 2009 4:18 PM