Filter
Top Products
60 Installing and Configuring Hardware
4
Open the release lever to disconnect the Modular Storage Controller Card
edge connector from the system board connector as illustrated in
Figure 4-14.
5
Lift the Modular Storage Controller Card straight up from the system
board as illustrated in Figure 4-14.
NOTICE: Do not apply pressure to the internal SAS port connectors as they could
be damaged.
NOTICE: Electrostatic discharge can damage sensitive components. Always use
proper antistatic protection when handling components. Touching components
without using a proper ground can damage the equipment.
Figure 4-14. Removing and Installing the Storage Controller Card
1 storage controller card 2 release lever
1
2
Dell_PERC6.1_UG.book Page 60 Wednesday, April 15, 2009 4:18 PM