Filter
Top Products
46 Installing and Configuring Hardware
1
Unpack the TBBU and follow all antistatic procedures.
NOTICE: When transporting a sensitive component, first place it in an antistatic
container or packaging.
NOTE: Handle all sensitive components in a static-safe area. If possible, use
antistatic floor pads and work bench pads.
2
With the DIMM removed from the controller, insert one end of the
battery pack harness (the red, white, yellow, and green wires) into the
connector on the memory module and the other end into the connector on
the battery.
3
Place the top edge of the battery over the top edge of the memory module
so that the arms on the side of the battery fit into their sockets on the
memory module. See Figure 4-5.
Figure 4-5. Installing a TBBU
4
Place the PERC 6/E adapter on a flat, clean, static–free surface.
1 battery 4 connector on the memory module
2 connector on the battery 5 memory module
3 battery pack harness
4
3
1
5
2
Dell_PERC6.1_UG.book Page 46 Wednesday, April 15, 2009 4:18 PM