Filter
Top Products
Installing and Configuring Hardware 61
Installing the Modular Storage Controller Card
To install your new CERC 6/i Modular Storage Controller:
1
Unpack the new CERC 6/i Modular Storage Controller Card and check for
damage.
NOTE: If the card is damaged, contact Dell.
2
Place the Modular Storage Controller Card onto the System Board.
Place by aligning the Modular Storage Controller Card such that the tabs
on the metal System Board tray fit through the notches in the edges of the
Modular Storage Controller Card.
3
Slide the Modular Storage Controller Card towards the connector on the
System Board until the Modular Storage Controller Card’s edge connector
clicks into place.
4
Reinstall the System Board. For more information on reinstalling the
System Board, see your system’s Hardware Owner’s Manual or the User’s
Guide.
5
Close the top cover of the Modular blade system. For more information on
closing the top cover of the Modular blade system, see your system’s
Hardware Owner’s Manual or the User’s Guide.
6
Reinstall the Modular blade system in the Modular blade system chassis.
For more information on reinstalling the Modular blade system into the
Modular blade system chassis, see your system’s Hardware Owner’s
Manual or the User’s Guide.
NOTE: The CERC 6/i Modular does not provide support for a battery backup unit.
NOTE: For the latest list of firmware and driver installation instructions, see the
system documentation located at the Dell Support website at support.dell.com.
Dell_PERC6.1_UG.book Page 61 Wednesday, April 15, 2009 4:18 PM