Filter
Top Products
Installing and Configuring Hardware 53
Removing the DIMM and Battery from a PERC 6/E
Adapter
NOTE: The TBBU on the PERC 6/E adapter consists of a DIMM and battery backup
unit.
This section describes how to remove the TBBU from a PERC 6/E adapter
that is currently installed in a system.
1 Perform a controlled shutdown on the system in which the PERC 6/E
adapter is installed,
as well as any attached storage enclosures, and remove
the PERC 6/E adapter from the system by following the instructions
detailed in "Removing the PERC 6/E and PERC 6/i Adapters" on page 50.
2
Visually inspect the controller and determine whether the dirty cache LED
on the DIMM is illuminated. See Figure 4-9. If the LED is illuminated,
reinsert the controller into the system, replace the system cover, reconnect
the system to power, turn the system on and repeat step 1.
Figure 4-9. PERC 6/E Adapter Dirty Cache LED Location
1 battery 3 dirty cache LED
2 memory module 4 PERC 6/E adapter
3
4
2
1
Dell_PERC6.1_UG.book Page 53 Wednesday, April 15, 2009 4:18 PM