Filter
Top Products
94 Removing and Installing Parts
www.dell.com | support.dell.com
8
Install the heat sink:
a
Insert the notched end of the heat sink onto the end of the retention base that is opposite
the hinge.
b
Lower the heat sink until it fits securely in the base.
c
When the heat sink is secured, pivot the rentention module clip back until the tab snaps
into place to secure the heat sink.
9
If you installed a processor replacement kit from Dell, return the original heat sink assembly
and processor to Dell in the same package in which your replacement kit was sent.
10
Replace the airflow shroud (see page 92).
11
Close the computer cover (see page 102).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into
the computer.
12
Connect your computer and devices to electrical outlets, and turn them on.
pin-1 corners of processor and
socket aligned
processor
processor
socket
socket lever
T2310bk2.book Page 94 Thursday, February 5, 2004 10:00 AM