Filter
Top Products
7 CONFIGURATION COMMAND Reference
102
7.2.5 MTP User Part
Syntax: MTP_USER_PART <si> <module_id>
Example: MTP_USER_PART 0x0a 0x2d
Configuration of a local user part module (other than a user part which has its
own config command in config.txt).
<si>
The service indicator.
<module_id>
The module id of the user process.
Note: This command must not be used when the corresponding configuration commands
are used (ISUP_CONFIG, TUP_CONFIG etc) as these commands automatically
perform the function of the MTP_USER_PART command.
7.3 ISUP Parameters
7.3.1 Global ISUP Configuration
Syntax: ISUP_CONFIG <res1> <res2> <user_id> <options>
<num_grps> <num_ccts> [<partner_id>]
Example: ISUP_CONFIG 0 0 0x2d 0x0435 4 128
The global configuration parameters for the ISUP module.
<res1>, <res2>
Reserved for backwards compatibility. These fields should be set to zero.
<user_id>
The module_id of the application running on the host that uses the ISUP
module.
<options>
A 16 bit value containing global run-time options for the operation of the
ISUP module. The meaning of each bit is as defined for the 'options'
parameter in the ISUP Configure Request message as detailed in the ISUP
Programmer's Manual