Filter
Top Products
Dialogic
®
DSI SPCI Network Interface Boards Programmer's Manual Issue 5
41
Description:
This message is used during initialization (or re-configuration) by the
application to reset a board and download the code file that contains the
operating software for the board.
The download operation is supervised by the device driver that reads the
binary format code file and transfers it to the board.
The confirmation message (if requested) indicates success by status of zero.
This implies that the reset operation has commenced but does not imply
completion. The application must then wait until a Board Status Indication
is received. This indicates either successful completion of the reset and
download operation or failure during the procedure.
Parameter Description:
board_type
The type of board to be reset. This must be set to 2 for DSI SPCI Boards.
phy_id
The physical ID for the DSI SPCI Board. This field must be set to the same
value as the board_id. (i.e., 0 … one less than the number of boards
supported).
code_file
Null terminated string giving the filename of the code file to be downloaded to
the board.
run_mode
Number taken from the following table to indicate which protocols are to be
run.
Note: It is only possible to activate protocols that have been licensed to run on the
board by use of a suitable license button.