Filter
Top Products
DES-3326S Layer 3 Fast Ethernet Switch User’s Guide
180 Web-Based Switch Management
Where the x’s represent the IP address to be
assigned to the IP interface named System and the
y’s represent the corresponding subnet mask.
4. Alternatively, you can enter DES3326S4# − enter
the commands config ipif System ipaddress
xxx.xxx.xxx.xxx/z. Where the x’s represent the IP
address to be assigned to the IP interface named
System and the z represents the corresponding
number of subnets in CIDR notation.
Using this method, the switch can be assigned an IP address
and subnet mask which can then be used to connect a
management station to the switch’s web-based management
agent.
Saving Configuration Changes
Clicking the Apply button makes any configuration change
active, but only for the current session. If the switch is
restarted (rebooted) without entering the configuration changes
into the non-volatile RAM (NV-RAM), the configuration changes
will be lost.
To enter configuration changes into the switch’s non-volatile
RAM, select Save Changes from the main screen. Click on the
Save Configuration button to enter the current configuration
into NV-RAM. The configuration will then be loaded into the
switch’s memory when it is restarted.