Filter
Top Products
DES-3326S Layer 3 Fast Ethernet Switch User’s Guide
196 Web-Based Switch Management
management agent. To change a switch’s order in the stack,
you must use the console Command Line Interface.
The number of switches in the switch stack (up to 6 − total) are
displayed in the upper right-hand corner of you web-browser.
The icons are in the same order as their respective Unit
numbers, with the Unit 1 switch corresponding to the icon in
the upper left-most corner of the icon group.
Figure 6-15. Switch Stack Display
In this case, there are two switches in the switch stack. The
Unit 1 (master) switch is on top and highlighted in blue. The
Unit 2 (slave) switch is below and not highlighted. To select a
switch in the switch stack to configure, simply click on the
corresponding switch’s icon.
Figure 6-16. Switch Stack Icons
Here, the switch Unit 2 (slave) has been selected.
When the up to 6 DES-3326S switches are properly
interconnected through their optional Stacking Modules,
information about the resulting switch stack is displayed under
the Stack Information link. This link is visible only when a
switch stack has been connected and the optional Stacking
Modules are active.