D-Link DVA-G3340S Network Router User Manual


 
DVA-G3340S User Manual Page 17 of 94 V1.00 AU
PPPoE and PPPoA Connection for WAN
Follow the instructions below to configure the Router to use a PPPoE or PPPoA for the
Internet connection. Make sure you have all the necessary information before you
configure the WAN connection.
1. If not already selected, choose the PPPoE/PPPoA option from the WAN
Settings pull-down menu. PPPoE/PPPoA is selected by default if you are
configuring the Router for the first time.
2. Under the ATM VC Settings at the top of the menu should not be changed
unless you have been instructed to change them. However, if you are instructed
to change the VPI or VCI values, type in the values assigned for your account.
Leave the PVC and Virtual Circuit setting at the default (Pcv0 and Enabled)
values for now. This can be used later if you are configuring multiple virtual
circuits for your ADSL service. For more information on ATM VC Settings, see
the table on page 31 below.
3. Under the PPPoE/PPPoA heading, type the User Name and Password used
for your ADSL account. A typical User Name will be in the form
user1234@isp.com.au, the Password may be assigned to you by your ISP or you
may have selected it when you set up the account with your ISP.
4. Choose the Connection Type from the pull-down menu located under the User
Name and Password entry fields. This defines both the connection protocol and
encapsulation method used for your ADSL service. The available options are
PPPoA VC-MUX, PPPoA LLC and PPPoE LLC. If have not been provided specific
information for the Connection Type setting, leave the default setting.
5. Leave the MTU value at the default setting (default = 1400) unless you have
specific reasons to change this (see table below).
6. Leave the MRU value at the default setting (default = 1492) unless you have
specific reasons to change this (see table below).
7. Leave the Default Route enabled if you want to use the Router as the default
route to the Internet for your LAN. Whenever a computer on the LAN attempts
to access the Internet, the Router becomes the Internet gateway to the
computer. If you have an alternative route for Internet traffic you may disable
this without effecting the Router’s connection.
8. NAT should remain enabled. If you disable NAT, you not be able to use more
than one computer for Internet connections. NAT is enabled and disabled
system-wide, therefore if you are using multiple virtual connections, NAT will
disabled on all connections.
9. The Firewall should remain enabled for most users. If you choose to disable this