Filter
Top Products
Hardware Preparation and Installation
MVME2500 Installation and Use (6806800L01H)
29
The following table shows the power available when the MVME2500 is installed in either a
three row or five row chassis and when PMCs are present.
2.3.3 Equipment Requirements
The following are recommended to complete a MVME2500 system:
VMEbus system enclosure
System console terminal
Operating system (and/or application software)
Transition module and connecting cables
2.4 Configuring the Board
The board provides software control over most options. Settings can be modified to fit the
user's specifications. To configure, set the bits in the control register after installing the board
in a system. Make sure that all user-defined switches are properly set before installing a
PMC/XMC module. For more information, see Switches on page 57.
Chassis Type Available Power Power With PMCs
Three Row 70 W maximum below 70 W
Five Row 90 W maximum below 90 W
Keep below power limit. Cooling limitations must be considered.