Filter
Top Products
10
3. Rotate the front bar once as shown, so the fabric folds around the bar.
4. Snap the connectors onto the front metal
rods.
5. Check underneath the printer for packing tape.
6. Raise the stabilizer knobs and unlock the casters. Then move the printer to the place
of use. (The casters are meant for moving the printer for only a short distance.) Lock
the casters and extend the stabilizer knobs after moving.
Connecting the Power Cord
Do not use an outlet that is controlled by an automatic timer or wall
switch. Otherwise, you may accidentally shut off the printer and
cause damage.
1. Connect the power cord to the AC inlet on the back of the
printer.
2. Route the power cord through one of the hooks on the left or right side as shown.
3. Plug the power cord into a properly grounded electrical outlet.
All Trademarks used in this document are the properties of their respective owners. Rev. 1.3 4/6/2004