Filter
Top Products
13
3. Make sure the printer is turned on. Press the Paper Source button until the Roll Auto
Cut light comes on.
4. Move the paper lever back to the released position.
5. Feed the paper into the slot.
6. Pull the paper down so it extends all the
way through the slot.
7. Turn the roll back to remove any slack.
Then align the bottom edge of the paper
with the horizontal row of holes, as
shown. (Do not extend the paper past the
row of holes).
8. Pull the paper lever forward to the locked
position, close the roll paper cover.
All Trademarks used in this document are the properties of their respective owners. Rev. 1.3 4/6/2004