Filter
Top Products
29
1. Press the Cleaning button and hold it for 3 seconds. The Pause light flashes as the
printer cleans its print head. The cleaning cycle takes about 60 seconds and does
not use any plates or paper.
2. When the Pause light goes off, print the nozzle check again to confirm that the head
is clean. You may need to run the cleaning 3-4 times to get a clean nozzle check
pattern. For effective cleaning, ALWAYS run a nozzle check between cleaning
cycles.
3. If after 3-4 cleanings, the nozzle check pattern still has missing dots, perform a
Power Cleaning as described below. You should not perform a power cleaning more
often than necessary, since it consumes amounts of ink.
Performing a Power Cleaning From the Control Panel
1. Press the SelecType button on the control panel. You will see PRINTER SETUP.
2. Press the Paper Feed up button until you see MAINTENANCE, then press
SelecType. You will see PWR CLEANING.
3. Press SelecType until EXEC appears on the display, then press enter.
The printer performs the power cleaning. Do not turn off the printer or interrupt this process
until it is complete.
If the lines on the pattern are still missing dots after running a power cleaning, contact
JetPlate Systems.
All Trademarks used in this document are the properties of their respective owners. Rev. 1.3 4/6/2004