Filter
Top Products
6
4
Chapter 2: Setting up the JetPlate 7600
Unpacking and Assembling the Optional Stand
The JetPlate is shipped in two boxes: the JetPlate box and the Platen box.
If you ordered the optional stand, you will have a third box.
Skip this step if you did not order the optional stand.
1. Unpack the optional stand if ordered, and make sure you have all these items. You
will also need a Phillips screwdriver.
Parts:
A: Base, right and left (1 each)
B: Leg, right and left (1 each)
C: Bottom support bar (1)
D: Top support bar (1)
E: Basket hooks (4)
F: Basket (1)
Accessories:
G: Allen wrench (1)
H: Bolts (4) for attaching lower bar to legs
I: Bolts (2) for attaching legs to base
J: Collars (2) for attaching lower bar to legs
K: Phillips screws with washers (4) for attaching top support bar to legs
L: Wing screws (2) for attaching printer to stand
M: Washers (2) for attaching printer to stand
2. Insert one of the legs into the base as
shown. (The bolt holes line up only if the
leg is matched with the correct base.) Use
the included Allen wrench to fasten the
leg with two bolts (H).
All Trademarks used in this document are the properties of their respective owners. Rev. 1.3 4/6/200