2. Installation
2.9 EtherNet/IP Board Installation
Following two board types can be used for the fieldbus I/O option EtherNet/IP.
- PCU-ETHIO
2.9.1 Board Appearance
Part names and functions of the scanner board are shown in the following figure. For details
of the status display LEDs, refer to the 4. Troubleshooting in this manual.
PCU-ETHIO
C0 C1 C2
JP1
JP1
0
1
D-Sub 9 pin
(Not in use)
Status Display LED (2)
EtherNetI/P Connector
4-pin Terminal
Watchdog Port
(Do not use this port.)
Jumper for Board Address
LED (2)
(
Not in use
)
2.9.2 Specifications
Part Number applicom PCU-ETHIO
Modes Master/Slave
Baud Rates 10, 100 Mbps
Interface EtherNet/IP 1 port
Maximum Node 127
Connection Type Cyclic, Change of State
Explicit messaging Yes
EDS support Yes
Input Data Size 1 to 505 bytes
Output Data Size 1 to 509 bytes
Automatic Detection Yes. Devices can be detected automatically.
54 Fieldbus I/O Rev.6