Filter
Top Products
15
Turning the Power on and Projecting Images
Basic
Operations
Turning the power off
Selecting the image source
Selecting the image source
If more than one signal source has been connected, or if no images are projected, use
the remote control or the projector's control panel buttons to select the signal source.
Using the remote control Using the control panel
Press the button that has the name of the port on it
that the desired signal source is connected to.
When you press , the selection menu is displayed.
Use or to select the signal source.
Press to accept.
Selection menu
When [Input A] port is connected
When connecting equipment to the [InputA] port, you may need to switch the image signal to
match the equipment.
< Remote control >
< Control panel >
While projecting an image from equipment
connected to the [InputA] port(s), press
to display the selection menu.
If "InputA" is selected, the selection menu will
be displayed.
Selection
menu
Use or to select the correct signal to match the
equipment.
Press or to accept.
If there is a problem with projection even though the projector is set up
and connected correctly, refer to s page 34.
Turning the power off
1. Turn the power off for the signal
sources that are connected to the
projector.
2. Remote Control
Press .
Control Panel
Pressing will display the following
message, so press once more.
3. When the projector has cooled down
(takes about 20 seconds) and the
"beep beep" tone sounds, disconnect
the power cable.
Simply turning off the power does not stop
electricity consumption.
4. Attach the lens cover.
5. Disconnect the cables that are connect-
ing other equipment to the projector.
QTip: