Filter
Top Products
28
Configuration Menu Functions
If "Aspectg" is set to "Zoom" when viewing images with subtitles, change the setting as follows so that the
subtitles are visible. The vertical size and the display position can both be adjusted together.
•Vertical Size
The vertical size of the image is
reduced so that the subtitles are
displayed.
•Zoom Position
The whole of the image is moved up
so that the subtitles are displayed.
During input of component video or RGB-video signals only, this permits alteration of the output scaling
(extent of the image projected).
Normal (92% display) :Input signals are projected at the normal image size. TV images are displayed at
92% size.
Larger :Component video and RGB-video images are displayed at 100% size.
The areas at the top, bottom and sides of images that cannot normally be seen are inserted and
projected. Interference may occur at the top, bottom and sides of the images depending on the image
signal. In such cases, try to adjust the display position.
s page 27
This is used to correct keystone distortion in images. The same correction can be carried out using the pro-
jector's control panel. s page 17
This should be set in accordance with the method used to set up the projector.
•Front : Select when the projector is set up in front of the screen.
•Front/Ceiling : Select when the projector is set up in front of the screen and suspended from a ceiling.
•Rear : Select when the projector is set up behind the screen.
•Rear/Ceiling : Select when the projector is set up behind the screen and suspended from a ceiling.
(This can only be set when NTSCg signals from composite video or S-Video are being input or when
525i/525p component video signals are being input.)
If using products designed for destinations such as South Korea that have different black level (setup level)
settings, use this function to obtain correct images. Check the specifications of the connected equipment
when changing this setting.
Sets whether "Direct Power ON" is enabled ("ON") or disabled ("OFF").
When you set to "ON" and leave the power cable connected to a wall socket, be aware of that sudden
surges of electricity that may occur when power comes back on after a power outage may cause the
projector to turn on automatically.
*1 The setting values are stored separately for each image source and signal type.
Zoom Caption *
1
Subtitle section
Use "Zoom Position" to
change the display position
of the image.
Use "Vertical Size" to
reduce the image size.
Projection area
Output Scaling *
1
Keystone
Projection
Setup Level *
1
Operation
Direct Power ON