Filter
Top Products
38
Problem Solving
Images appear dark
Projection stops automatically
Problems when projection starts
Power does not turn on
Other problems
No sound can be heard or the sound is faint
Have the colour intensity and
tint been adjusted correctly?
Use the "Color Saturation" and "Tint" menu commands to adjust the
colour and tint.
s "Image"- "Picture Quality" - "Color Saturation", "Tint" page 26
Has the image brightness been
adjusted correctly?
Use the "Brightness" menu commands to make the adjustments.
s "Image" - "Picture Quality" - "Brightness" page 26
Has the image contrastg
been adjusted correctly?
Use the "Contrast" menu command to adjust the contrast.
s "Image" - "Picture Quality" - "Contrast" page 26
Is the lamp due for
replacement?
When the lamp is nearly due for replacement, the images will
become darker and the colour quality will become poorer. When this
happens, the lamp should be replaced with a new one. s page 42
Is sleep mode active?
When "Sleep Mode" has been set to ON, the lamp turns off
automatically if no signal is input for about 30 minutes, and the
projector switches to standby mode. Press the button on the
remote control or the button on the projector's control panel to
turn the projector's power back on. To cancel the sleep mode setting,
change "Sleep Mode" menu command to "OFF".
s "Setting" - "Operation" - "Sleep Mode" page 29
Have you pressed the [Power]
button?
Press on the remote control or on the projector's control
panel.
Is "Child Lock" set to "ON"?
If the "Child Lock" menu command is set to "ON", press on the
projector's control panel for about 3 seconds or press on the
remoto control to turn the power on.
s "Setting" - "Operation" - "Child Lock" page 29
Are all of the indicators
switched off?
Disconnect the power cable and then reconnect it. s page 14
Check the circuit breaker to see if power is being supplied.
Do the indicators turn off and
on when the power cable is
touched?
Turn the power off, disconnect the power cable and then reconnect it. If this
does not solve the problem, there may be a problem with the power cable.
Then contact your dealer or the nearest address provided at "International
Warranty Conditions" in
Safety Instructions/World-Wide Warranty Terms
booklet.
Is the audio source connected
correctly?
Check that the cable is connected to the [Audio] input port.
Has the volume been adjusted
to the minimum setting?
Adjust the volume so that sound can be heard. s page 17
Is A/ V Mute mode active?
Press on the remote control to cancel the A/V mute.
Only when projecting
images from a video
source