Filter
Top Products
18 Displaying and Adjusting the Image
Projecting the Image
Make sure your projector and other equipment are set up as described
on the Quick Setup sheet or on page 45 (for desktop, video, or other
installations). Then follow the instructions below to start the projector
and display an image.
Turning On the Projector
Turn on any connected computer or video equipment before starting
the projector so it can automatically detect and display the image
source. If you turn on the projector first, or have multiple pieces of
connected equipment, you may have to select the image source
manually (see page 20).
Follow these steps to turn on the projector:
1. Remove the lens cap.
2. Plug one end of the power cable into the projector, and the other
end into a grounded electrical outlet.
The
Power light turns orange, indicating it is in standby mode.
note
If the Direct Power ON
feature has been enabled (as
described on page 30), the
Power light flashes green
when you plug it in. When
the light stops flashing and
stays green, the projector is
ready. Skip to step 4.
Power light