Filter
Top Products
Managing Projectors 91
3. EMP NetworkManager connects to the projector, and you see
this screen:
4. Verify that the network settings are correct. (If DHCP is on, you
don’t need to verify network settings.)
■ Make any desired changes to the projector’s network address
configuration (turning off DHCP enables the manual
settings).
■ You can give the projector a name—up to 15 characters long,
including the following symbols:
! @ # $ % ^ & ' . - _ { } ~
Naming the projector helps you identify it in EMP Monitor
and EMP NetworkManager, especially if you’re managing
more than a few of them.
5. Click
Mail Notification Settings.
note
The projector must be
plugged in (projecting or in
Standby Mode) for you to be
able to connect to it.
To access a projector in
Standby Mode, you must
select
Network ON as the
Standby Mode setting in
the projector’s menu system
(see page 75).
Remember that when
Standby Mode is set to
Network ON, the exhaust
fan continues to operate
after the projector has cooled
down. This is normal.