Filter
Top Products
Fine-Tuning the Projector 73
Controlling Multiple Projectors
If you’re using more than one projector for your presentation, you can
switch between them using a single remote control. To do this, you
need to set a different ID for each projector. During the presentation,
you can change the remote control’s ID to match that of the projector
you want to use.
Setting the Projector ID
The projector’s default ID is 1. Follow these steps to change it:
1. Press the
Menu button on the remote control.
You see the projector’s menu screen.
2. Select the
Extended menu and press Enter.
3. Highlight
Projector ID and press Enter.
4. Choose an ID value for the projector and press
Enter.
5. When you’re done, press
Esc to exit the menu system.
note
By default, the remote
control’s ID is set to zero,
which allows it to control
any projector. If you want to
control multiple projectors
simultaneously, and you
don’t want to switch
between them (each
projector would need its own
screen), you can leave the
remote control’s ID set to
zero.