Filter
Top Products
80 Managing Projectors
Connecting and Configuring the
Projector on a Wired Network
Before using the EasyManagement software to manage your
projector(s), you have to connect each projector you want to monitor
to your network and configure it with an appropriate IP address. You
can connect and configure the projector using the network port.
Follow these steps to connect and configure the projector for your
network.
1. Connect the projector to your network using a commercially
available 100baseTX or 10baseT network cable.
2. Turn on the projector (see page 18).
3. Press the
Menu button on the remote control and select Network
from the
Extended menu.
4. If your network assigns addresses automatically, turn on
DHCP.
If your network does not assign addresses automatically, turn off
DHCP and enter the projector’s IP Address, Subnet Mask, and
Gateway Address, as needed.
■ To enter numbers using the remote control, press the Num
button until it lights, then use the number keypad shown
below.
note
If you’re a network
administrator, you can use
the
SNMP option to enter a
trap IP address. This lets you
receive trap alerts for the
projectors you’re monitoring.