Filter
Top Products
Resuming From an Error
If an error occurs during a test, the test stops at that point and an
error code and error message are displayed. If you want to record
the problem, you can print out the message on your printer. You see
this prompt:
Do you want a printout of the error
message(s) (Y/N)?
To continue without printing the error message, press N and Enter.
To request a printout, first make sure your printer is turned on and
on-line, with paper loaded. Then press Y and Enter. If the printer
is not ready, the following message is displayed:
Printer is not installed correctly.
Install correctly and enter Y, or
Enter N to cancel printing.
Correct the problem and press Y and Enter to continue printing, or
press N and Enter to cancel printing.
After printing the error message, the program displays this prompt:
Printout is finished. Press Enter to
return to the menu.
The program continues after an error in one of the following ways:
l
It returns to the DEVICE LIST, or
l
If you are running multiple tests and are not terminating on an
error, the program repeats the test that caused the error.
The remainder of this appendix describes the tests you can run on
the system’s internal devices and on the optional devices connected
to your computer. The program displays the titles of each test on
the screen.
For a complete list of the error codes and messages that are
displayed by these tests, see the table at the end of this appendix.
Performing System
Diagnostics
D-5