Filter
Top Products
Caution
Do not plug in the power cord yet. You should perform the first three
steps before you plug in the printer and turn on the power,
Remove the tape that holds the dust cover in place during shipping
and
take
the cover off the printer. Simply tilt the dust cover up and lift it
off.
Installing the paper feed knob
Install the paper feed knob on the right side of the printer, as shown
in Figure 1-2. Line up the flat side of the hole in the knob with the flat
side of the shaft, then push the knob firmly into place.
Now that you’ve installed the paper feed knob, use it to remove the
sheet of paper that is behind the printer’s platen (the black roller).
Removing the print head protector
Remove the print head protector by lifting it up and pulling it to the
right as shown in Figure 1-3 below.
1-2
Setting Up the Printer