Filter
Top Products
The switches are in two groups of eight and are numbered from l-l
to 2-8. As you can see in the example below, the first part of the self test
shows the settings of the switches.
Condensed
OFF
Zero
0
CG Table
Italic
MODE
ESC/P
Print Quality Draft
Country
U.S.A.
Page Length 11”
Sheet Feeder
OFF
Skip-Over-Perf.
OFF
Auto LF
OFF
Interface
Parallel
You will find your own self test printout helpful as you use this
section.
Before you change any DIP switch settings, turn the printer around to
give you easy access to the switches. You can easily turn the switches
on and off with a thin pointed object, such as a small screwdriver or the
cap of a ballpoint pen. The switches are
ON
when they are UP and OFF
when they are DOWN. In the tables that follow, shaded boxes indicate
the factory settings.
Note
When you change a DIP switch setting, turn off the power, reset the
switch or switches, then turn on the power again. The printer checks
and recognizes new settings only at the time you turn the power on.
Interface settings
If you are using a parallel interface, the interface line of the self test
DIP switch printout should be the following:
Interface
Parallel
1-14
Setting Up the
Printer