Filter
Top Products
5. Place the paper on the paper guide with its left edge next to the edge
tab as shown in Figure 1-10 below. Push the paper firmly into the
printer, then let go of it.
6. Pull the paper bail lever forward to the single-sheet loading position
(indicated by the icon). This makes the paper feed into the printer
until it is past the paper ball.
7. When the paper stops, push the paper bail lever back to the printing
position. This makes the paper feed backward until only its top edge
is under the paper bail.
If the platen (the black roller) turns but the paper does not load,
remove the paper from the printer and try again, starting at Step 3. This
time press the paper a little more firmly into place.
If nothing happens at all, see that the printer is turned ON and that
the
ON LINE
light is off. Then remove the paper and try again.
Figure 1-1O.
Aligning the paper
Paper
bail
1-10
Setting Up the Printer