Filter
Top Products
Serial Interface Settings
If you are using an optional serial interface, you may need to change
the communications protocol of the printer or the computer for them to
communicate properly The protocol used by the printer is decided by
one or two groups of DIP switches located on the serial interface board;
the protocol used by the computer can probably be altered by a
software command. It is essential that the printer and computer use
compatible protocols.
If you can, change the settings on the computer rather than the
interface board because the interface is set up at the factory to give
optimum performance in a wide range of conditions. If your dealer has
installed the interface for you, he or she should also be able to adjust
the computer and interface to achieve a good match.
If you do need to change the settings on the interface yourself,
(perhaps in order to use a different computer), the tables below will help
you match the computer and interface. The settings given in the table
cover the conventions used by the computer and printer as data is
transferred. There are other DIP switches and jumpers,
but
for most
purposes you only need change the settings described here. The other
settings are described in the manual supplied with the interface.
Choosing and Setting Up Optional Interfaces
F-7