Filter
Top Products
5
Changing Printer Settings From the Printer’s Control Panel
5-9
Sun-E+
Rev. C
A5 size Chap5.fm
4/15/99 Pass 0
R
Proof Sign-off:
<Crestec> _______
<Yamanouchi> _______
<Crestec> _______
Roll paper
When you turn on this mode, the printer recognizes that the
paper is not single sheets, so it does not try to eject the paper and
advance it forward to the next page when you press the
LF/FF
button.
Changing default settings
Follow the steps below to enter the default-setting mode and
change the printer’s default settings.
Note:
❏
To print the language selection and default-setting mode
instructions, you need three sheets of A4- or letter-size single-sheet
paper or three pages of continuous paper that is at least 279 mm
(11 inches) long and 210 mm (8.27 inches) wide. See Chapter 2 for
instructions on loading continuous paper, or Chapter 3 for
instructions on loading single sheets.
❏
If you use single sheets, you need to load a new sheet of paper each
time the printer ejects a printed sheet.
1. Make sure paper is loaded and the printer is turned off.
c
Caution:
Whenever you turn off the printer, wait at least five seconds
before turning it back on; otherwise you may damage the
printer.
2. Hold down the
Pitch
button while you press the
Operate
button to turn on the printer. The printer enters the default-
setting mode and prints the language selection instructions
(one page).
3. Press the
Pitch
button until the Pitch lights indicate the
language you want, as described in the language selection
instructions.