Filter
Top Products
2-8
Printing on Continuous Paper
Sun-E+
Rev. C
A5 size Chap2.fm
4/15/99 Pass 0
L
Proof Sign-off:
<Crestec> _______
<Yamanouchi> _______
<Crestec> _______
Using the Front Push Tractor
To use the front push tractor, load continuous paper in the front
slot. For more information on when to use the front push tractor,
see “Available Paper Paths” on page 3.
Note:
The tractors are installed in the front push and rear push positions when
the printer is shipped. The rear push tractor cannot be removed.
Installing the tractor in the front push position
If a tractor is installed in the front push position, skip to “Loading
paper onto the front push tractor“ on the next page.
If a tractor is installed in the pull position, you need to remove it,
and replace the paper tension unit as described on page 2-33
before using the front push tractor.
To install the tractor in the front push position, follow these steps:
1. Make sure the printer is turned off.
2. Open the front paper guide by pulling the tab at the center
of the guide. Then remove the guide by grasping both sides
and pulling it straight out of the printer.
tab
2-10.eps