Filter
Top Products
14 Using the Printer
Control Panel Buttons and Lights
Tear Off (Font) button*
Advances continuous paper to the
tear-off position.
Feeds continuous paper backward from
the tear-off position to the top-of-form
position.
*Font select
In the Micro Adjust mode, you can select the font to use for printing
by pressing the Tear Off button. The Tear Off lights turn on, off or
flash to indicate the selected font.
**Micro Adjust mode
When you hold down the Pause button for three seconds, the printer
enters the micro adjust mode. In this mode, you can press the
LF/FFD and Load/EjectU buttons to adjust the top-of-form or
tear-off position. See “Using the Printer” on page 13
Pause button
Stops printing temporarily,
and resumes printing when
pressed again. When
pressed for three seconds,
turns on the Micro Adjust
mode**. To turn off, press
again.
Pause light
On when the printer is
paused.
Flashes when the printer is
in the Micro Adjust
mode**.
Flashes when the print head
has overheated.
Paper Out light
On when no paper is
loaded in the selected
paper source or when
paper is not loaded
correctly.
Flashes when paper has
not been fully ejected or
a paper jam has occurred.
LF/FF button**
Feeds paper line by line
when pressed and
released.
Ejects a single sheet or
advances continuous
paper to the next
top-of-form position
when held down.
Load/Eject button**
Loads a single sheet of paper.
Ejects a single sheet of paper
if a sheet is loaded.
Loads continuous paper
from the standby position.
Feeds continuous paper
backwards to the standby
position.
Tear Off (Font) lights*
Flash when continuous paper is in the
tear-off position; otherwise, the lights
indicate the selected font.