Filter
Top Products
Getting to Know Your Printer 9
❏ Unplug the printer and refer servicing to qualified personnel
under the following conditions:
❏ Adjust only those controls that are covered by the operating
instructions.
❏ If you plan to use the printer in Germany, observe the
following:
To provide adequate short-circuit protection and
over-current protection for this printer, the building
installation must be protected by a 10- or 16-amp circuit
breaker.
Note for German-speaking users:
Bei Anschluss des Druckers an die Stromversorgung muss
sichergestellt werden, dass die Gebäudeinstallation mit einer
10 A- oder 16 A-Sicherung abgesichert ist.
Hot Parts Caution Symbol
i. If the power cord or plug is damaged.
ii. If liquid has entered the printer.
iii.If the printer has been dropped or the cabinet damaged.
iv. If the printer does not operate normally or exhibits a
distinct change in performance.
K
This symbol is placed on the print head to indicate that
the print head may be hot. Never touch the print head
just after the printer has been used. Let the print head
cool for a few minutes before touching it.