Filter
Top Products
22 Section 4: Ribbons and Cards
4250/4225 Card Printer UserÕs Manual
2. The supply end of the ribbon is the side with the fresh, unused ribbon on it.
The ribbon take-up is the other end.
3. Open the Top Cover of the printer by pressing the Cover Release Button.
4. With the cover open, place the supply end of the ribbon in between the two
black Ribbon Drive Hubs located on the right-hand side of the printerÕs
interior. Make certain that the ribbon is fed from underneath the ribbon roll.
HINT: The Ribbon Drive Hub nearest you, as you are looking into the printer
from the front, is spring loaded. Use the end of the ribbon supply core to push
in this Ribbon Drive Hub when inserting the ribbon.
5. Place the take-up end of the ribbon roll in between the two black Ribbon Drive
Hubs located on the left-hand side of the printerÕs interior. Load the ribbon
take-up end of the ribbon just as you loaded the ribbon supply end in step 4.
When loaded properly, the ribbon should feed underneath both ends of the
ribbon roll as shown in this side view illustration.
Supply
Take-up
Supply Ribbon
Drive Hubs
Take-up Ribbon
Drive Hubs
510291_card printer 11/24/98 12:18 PM Page 22