Filter
Top Products
66 Section 9: Troubleshooting
4250/4225 Card Printer UserÕs Manual
BOTH Lines of LCD
Message Cause Solution
CANCEL=Abort Appears when the Pause/ Press the Pause/Resume
RESUME=Continue Resume button is pressed button to return the printer
any time while the printer to its ÒReadyÓ mode or, if
is powered ON. Also printing, to continue
appears when the On/ operation. Press the
Cancel button is pressed On/Cancel button to abort
during a print job. the current print job and
completely clear the
printerÕs memory.
CANCEL=Abort Appears when the Press the Pause/Resume
RESUME=Reprint On/Cancel button is button to continue printing
pressed after an error the current print job where it
has occurred. left off, once the error is
cleared. Press the On/Cancel
button to abort the current
print job and completely
clear the printerÕs memory.
DRAM Memory Bad! The printerÕs 2 MB Disconnect printerÕs power,
Service Required memory module is bad or remove the printerÕs back
not installed properly. cover, and check that the
memory module is seated
properly in its socket. If it is
and this error message still
appears, replace memory or
call for technical assistance.
EE Memory Error! Indicates problem with Remove the ribbon and
RESUME=Clear Mem permanent circuit board press the Pause/Resume
memory. button to recalibrate the
printerÕs memory module.
Turn the printer power OFF
and ON to reset.
EE Memory Error! Permanent circuit board Call for technical assistance.
RESUME=Retest memory is bad.
510291_card printer 11/24/98 12:19 PM Page 66