Filter
Top Products
TOP Line of LCD (continued)
Message Cause Solution
Mag Encoding Indicates Mag Stripe is
being encoded.
Mag-down Failed Magnetic encoding head is Press the Pause/Resume button
unable to lower. to retry.
Mag-up Failed Magnetic encoding head is Press Pause/Resume button to
unable to raise. retry. If failure continues, verify
that your printer does have a
magnetic encoding head, or look
for anything that may be jammed
around the head. If your printer
has a magnetic head, it should be
located directly beneath the last
Card Feed Roller on the card
output side of the printer.
Mag Verify Error The mag stripe was not Press the Pause/Resume
encoded properly. button to resume encoding.
Mag Verifying Indicates data on mag
stripe is being verified.
Print Cover Open The Top Cover is not Check that nothing is blocking
properly shut. the cover from being shut and
close the cover.
Printer Ready Indicates printer is ready
to print.
Printing Indicates printer is printing.
Printing Yellow Indicates print ribbonÕs
yellow panel is printing.
Printing Magenta Indicates print ribbonÕs
magenta panel is printing.
Printing Cyan Indicates print ribbonÕs
cyan panel is printing.
Printing Black Indicates the print ribbonÕs
black panel is printing.
Printing Overlay Indicates print ribbonÕs
overlay panel is printing.
Printing Resin Indicates a resin-only
ribbon is printing.
Section 9: Troubleshooting 63
4250/4225 Card Printer UserÕs Manual
510291_card printer 11/24/98 12:19 PM Page 63