FARGO electronic L000286 Printer User Manual


 
RESTRICTED USE ONLY Fargo Electronics, Inc.
CardJet 410 Card Printer/Encoder and Persona CardJet C7 Printer User Guide (Rev. 6.1)
2-59
Technician Handbook for CardJet Card Printers (continued)
Term Description
Power Supply
Fargo supplies both cord sets for Internal power supply. (Note: This
provides a dual power supply (110v/220v).)
Printer
connected to a
domestic US
power source
1. Connect the Printer to a domestic US power source via appropriate
power cord, to start-up the Printer. (Note: Normal device
initialization and Firmware downloading. Printer start-up is initiated.
The cards are printed with acceptable color reproduction and image
placement when the Operator selects normal Printer Driver
preference options and initiates a print job.)
2. Select the normal Printer Driver preference options and start a print
job. Ensure that the cards are printed with acceptable color
reproduction and image placement.
Printer Drive
Fuel Gauge
(used for
monitoring ink
levels)
The Printer Driver Fuel Gauge correctly provides the Operator with a
display of the estimated amount of ink remaining in the Cartridge when
the Operator requests it.
Ink Levels: The Printer is set up to ensure the appropriate ink
levels exist before starting each print job.
Monochrome/Color Cartridge: The Printer provides a fuel gauge
in Printer Driver to monitor both monochrome and color Cartridge.
Each Cartridge is monitored individually.
Ink Low message: The Fuel Gauge provides an onscreen
Operator warning for Ink Low.
Ink Out message: The Fuel Gauge provides a definitive Ink Out
message on screen and LED flash. (Note: It resumes without error
after an Ink Cartridge is replaced if ink runs out in the middle of a
batch print.)
Continued on the next page