Filter
Top Products
Chapter 9 Messages
9.3 Detailed Error Codes
ETERNUS VSS Hardware Provider 2.1 User’s Guide
Copyright 2012 FUJITSU LIMITED P3AM-4582-03ENZ0
126
invalid OLU. Check the device that is the copy source or the device
partition information of the copy destination, and retry the
function. If this error still occurs, collect material for
troubleshooting, and then contact your Fujitsu system
engineer (SE).(*1)
invalid BoxID. Check the connection conditions between cabinets, and retry.
If this error occurs again, then contact your Fujitsu customer
engineer (CE).
invalid Role. Check the connection conditions between cabinets, and retry.
If this error occurs again, then contact your Fujitsu customer
engineer (CE).
setup is inadequate Take one of the following actions:
• Checking/Setting the license of the Advanced Copy option
• Checking/Setting device resources such as "Unset table
size", "Lack of table size", and "Unset REC buffer size".
communication interrupted. Check the connection state between the cabinets, and retry
processing. If the error occurs again, contact a Fujitsu
systems engineer (CE).
the session mode was not changed. Check the connection status between cabinets and then retry.
If this error occurs again, call your Fujitsu customer or
systems engineer (CE or SE).
the session mode crosses. Check the connection status between cabinets and then retry.
If this error occurs again, call your Fujitsu customer or
systems engineer (CE or SE).
the operation of SnapOPC was failed. Take one of the following actions:
• Check the partition information for the copy destination
disk, and then rerun the command.
• Check the status of SnapOPC session, and then try again.
• SnapOPC is not supported by this device. Try again using
SnapOPC+.
If this error occurs again, call your Fujitsu customer or
systems engineer (CE or SE).
the operation of REC buffer was failed. Check the settings status of the REC transfer buffer and then
rerun the command. If this error occurs again, call your Fujitsu
customer or systems engineer (CE or SE).
the operation of concurrent suspend was
failed.
Check the status of all sessions, and then rerun the
command. If this error reoccurs, call your Fujitsu customer or
systems engineer (CE or SE).
invalid Snap Data volume. Take one of the following actions:
• When a copy type is SnapOPC/SnapOPC+, check that
the copy destination is the Snap Data Volume.
• When a copy type is SnapOPC/SnapOPC+, check that
the copy source is not the Snap Data Volume.
• When a copy type is a type other than SnapOPC/
SnapOPC+, check that the copy destination and source
are not the Snap Data Volume.
• For Snap Data Volume initialization, check that the Snap
Data Volume is specified.
If this error occurs again, call your Fujitsu customer or
systems engineer (CE or SE).
Detailed error code Action