Fujitsu 2.1 Network Hardware User Manual


 
Chapter 8 Commands
8.6 OLU Number Display Command (stxvgetolu)
ETERNUS VSS Hardware Provider 2.1 User’s Guide
Copyright 2012 FUJITSU LIMITED P3AM-4582-03ENZ0
62
Reference
Identifying if a command ends normally
An error has occurred if a message includes one of the following error levels:
"ERROR"
"WARNING"
Notes on identifying if a command ends normally
The following message appears if any disks other than disks in the ETERNUS Disk storage system
are detected with this command.
"STXV0603 INFO Disk is not a Disk Storage Systems."
This message does not mean an error has occurred. This message indicates that the detected disk
is not a LUN from the ETRERNUS Disk storage system. If a device other than the ETERNUS Disk
storage system is connected to, this message always appears. When this message is displayed,
determining the relevance of the contents of this message may be required.
The output of this message can be checked with the following message number:
"STXV0603"
An example of an output message is shown below.
- When all of the OLU information is output in an environment in which an internal disk and the
ETERNUS Disk storage system are connected..
- When the OLU information of an internal disk with the specified disk number is output in an envi-
ronment in which an internal disk and the ETERNUS Disk storage system are connected.
> stxvgetolu
Disk, OLU, BoxID/Message, VOL,Maxgen
0, , STXV0603 INFO Disk is not a Disk Storage Systems.
1, 0x000a, 00E2000#######E210S4B#####JD4170832013##,---,-
> stxvgetolu -p 0
Disk, OLU, BoxID/Message, VOL,Maxgen
0, , STXV0603 INFO Disk is not a Disk Storage Systems.