Fujitsu fi-6130 Scanner User Manual


 
ATTENTION
Carbonless paper contains chemical substances that may harm the Brake roller or
paper-feeding rollers (e.g. Pick roller) when documents are fed. Pay attention to the
following:
Cleaning:
If document jams occur frequently, clean the Brake roller and the Pick roller.
For details on cleaning the Brake roller and the Pick roller, see Chapter "
4. DAILY
CARE."
Replacing parts:
The service life of the Brake roller and the Pick roller may be shortened compared to
that of the rollers used for scanning wood containing paper documents.
If paper containing wood is scanned, the service life of the Brake roller and the Pick
roller may become shorter than that of the rollers used for scanning only woodfree
paper.
The Brake roller or Pick rollers of the scanner could be damaged if photographs or
sheets of paper attached to the scanned document have contact with the Brake or
Pick rollers during scanning.
Scanning documents of calendered paper such as photographs may damage the
surface of them.
HINT
When using the ADF, the leading edge of all document sheets must be evenly aligned. Make
sure that curling at the leading edge is within the following tolerances:
ATTENTION
This scanner can scan ID cards through the Automatic Document Feeder. Follow the
precautions below.
You can place up to three cards at a time into the Automatic Document Feeder.
If the card is embossed (i.e., a card with raised lettering), place one card at a time.
It is recommended that the front side of the card be placed face down in the
Automatic Document Feeder.
The card to be scanned should be within the ISO7810 compliance, type ID-1.
Dimensions: 3.4 inch (height) x 2.1 inch (width)/ 86 mm x 54 mm