Filter
Top Products
fi-6130 / fi-6230 Image Scanner Operator's Guide
TROUBLESHOOTING
CONTENTS MAP
TOP
3.4 Scanning Documents of Different Widths
When you scan documents of different widths at one time from the ADF, some documents that are small in paper size may
be skewed or may not be fed into the scanner. It is recommended that only documents of the same width be scanned at one
time.
In the case where you have to scan documents of different widths together, scan them, following the procedure below.
1. To prevent images from skewing, select [Automatic Page Size Detection] from the [Automatic
Size and Skew Detection] drop-down list.
For details, see Section "3.10 Correcting Skewed Documents."
2. Center all documents as shown in the figure below.
3. Place the documents on the ADF paper chute, and then adjust the side guides so that they lightly
touch the widest sheets of paper.
ATTENTION
When placing a stack of documents on the scanner, make sure that all documents are
directly under the pick roller. Off-center documents, which are not under the pick roller,
cannot be fed into the scanner.
4. From the ScandAll PRO window, perform a scan.
For information about how to scan documents, see Section "
2.6 How to Use ScandAll PRO."
Scanned document images are displayed in the ScandAll PRO window.
All Rights Reserved. Copyright 2007 © PFU LIMITED