Gateway 7001 Series Network Card User Manual


 
205
www.gateway.com
United States of America
Federal Communications Commission (FCC) Intentional emitter per FCC Part 15
The power output of the AP is well below the RF exposure limits as known at this time. Because this wireless
device emits less energy than is allowed in radio frequency safety standards and recommendations, Gateway
believes these devices are safe for use.
Regardless of the power levels, care should be taken to minimize human contact during normal operation.
Measurements have been performed to show that the RF exposure is below what is considered safe limits;
however care should be taken to make sure the user or bystanders keep the transmitter away from their body
when the wireless device is transmitting. The transmitting antenna should be installed and used in a manner to
maintain 20cm (8 inches) from user’s or bystander’s bodies.
This wireless device is intended to be used indoors. In some areas, use of this device outdoors is prohibited.
Operation of this device is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation of the device.
Unintentional emitter per FCC Part 15
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio or television
reception. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause interference to radio and television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help.
Compliance Accessories: These accessories are required to be used in order to ensure compliance with FCC rules:
The AC Adapter supplied with the device.
Wireless Channels: Gateway declares that the Gateway 7001 802.11 A+G Wireless Access Point is limited to
channels 1 through 11, specified by firmware controlled in the USA.
Warning In order to comply with FCC requirements this transmitter must not
be operated (or co-located) in conjunction with any other transmitter
or antenna.
Warning Wireless devices are not user serviceable. Do not modify them in any
way. Modification to a wireless device will void the authorization to
use it. Please contact Gateway for service.