Filter
Top Products
Installing memory
www.gateway.com
43
To install or replace memory:
1 Follow the instructions in “Preventing static electricity discharge” on
page 30. Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
2 Follow the instructions in “Opening the server case” on page 31.
3 Pull the plastic tabs (1) away from the sides of the memory module slot.
If you are replacing a memory module, lift the old module (2) out of the
slot.
4 Align the notch on the new module with the notch in the memory module
slot and press the module firmly into the slot. The tabs on the sides of the
memory slot should secure the memory module automatically.
5 Follow the instructions in “Closing the server case” on page 32.
6 Turn on the server and open the BIOS setup utility. Verify the System
Memory
listed in the Main menu. When you exit the BIOS setup utility
make sure that the operating system completely loads. If you receive an
error, see “Memory” on page 90.