Filter
Top Products
Installing and removing an optional mezzanine board
www.gateway.com
57
4 Align the holes on one side of the board with the plastic standoffs (1) and
align the other side with the mezzanine board slot (2).
5 Push down on the board (3) to seat it in the mezzanine board slot and onto
the plastic standoffs until the retaining tabs snap into place.
6 Replace the PCI riser card assembly by following the instructions in
“Installing and removing PCI expansion cards” on page 44.
7 Follow the instructions in “Closing the server case” on page 32.
To remove an optional mezzanine board:
1 Follow the instructions in “Preventing static electricity discharge” on
page 30. Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
2 Follow the instructions in “Opening the server case” on page 31.
3 Remove the PCI riser assembly by following the instructions in “Installing
and removing PCI expansion cards” on page 44.
4 Push aside the plastic retaining tabs (1) and pull the mezzanine board (2)
out of the mezzanine board slot.
5 Replace the PCI riser card assembly by following the instructions in
“Installing and removing PCI expansion cards” on page 44.
6 Follow the instructions in “Closing the server case” on page 32.
2
3