Filter
Top Products
Installing and removing PCI expansion cards
www.gateway.com
45
6 If you are not replacing the card, install a slot cover (5) on the back of the
riser card assembly.
7 If you are replacing the riser card, continue with the next step.
- OR -
If you are replacing the PCI card, go to Step 10.
8 Press the locking tab (6) holding the riser card in the riser card assembly,
then push the riser card in the direction shown (7) to unlock and remove
it from the standoffs.
9 Insert the new riser card into the riser card assembly, then push it toward
the back of the assembly. It should snap into place.
10 Insert the new PCI card into the riser card, making sure any connectors
extend through the slot at the back of the assembly and that the card is
fully seated in the riser card.
11 Replace the card lock to secure the card to the riser card assembly.
12 Position the PCI riser assembly over the PCI sockets on the server board,
Then press the PCI riser assembly into the PCI sockets until it clicks into
place.
13 Follow the instructions in “Closing the server case” on page 32.
14 See the card’s documentation for software installation instructions.
6
7