Filter
Top Products
Replacing the system board
www.gateway.com
61
Replacing the system board
To replace the system board:
1 Follow the instructions in “Preventing static electricity discharge” on
page 30. Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
2 Follow the instructions in “Opening the server case” on page 31.
3 Remove the PCI riser assembly by following the instructions in “Installing
and removing PCI expansion cards” on page 44.
4 Remove the fan duct and system fan cage by following the instructions
in “Replacing system fans” on page 46.
5 Remove the memory modules by following the instructions in “Installing
memory” on page 40.
6 Remove the heatsinks and processors by following the instructions in
“Replacing or adding a processor” on page 49.
7 Disconnect all cables from the system board, noting their locations and
orientation. (You will reconnect the cables after you install the new board.)